Ignition "On" Remote Module for X Inverter
The Ignition "On" Remote Module for the X Inverter runs in series with the original remote panel. By applying a 12v or /24v voltage to the Ignition spade terminal on the EN1IGN remote module, the inverter will turn on. No voltage, the inverter will turn off.
| Part Number |
|---|
| ENE-EN1IGN |
CDI Electronics
CDI Mercruiser Ignition Coil & Module (V6 & V8) Mercruisers, OMC and Volvo-Penta Engines. 2001 and newer 4.3L, 5.0L, 5.7L & 6.2L with 555 ECM Replaces: 18-5465, 3861985, 392-863704T,...
CDI Electronics
CDI Mercruiser Ignition Module - E11-0003 Application: Ignition module for Mercruiser inboard Replaces Original OE Part Numbers: 18-5107-1, 3854003, 7243110, 73190, 802464, 804412, 811637,...
Victron
Victron Inverting Remote On-Off Cable The Inverting remote on-off cable is intended for products which require active pull down of the remote control terminal to switch on, while the source signal...
Sierra Marine
Sierra Ignition Module - Mercruiser - S18-5107-1. Replaces: 3854003 4/6/8 cyl Part Number SRA-S18-5107-1
Victron
Victron Non-inverting remote on-off cable Use this cable to connect the following products to the VE.Bus BMS: - Skylla-TG all models The cable translates the remote on/off driver logic from the VE...
Victron
Victron VE.Direct Non Inverting Remote On-Off Cable Use this cable to remotely control BlueSolar and SmartSolar MPPT charge controller models. Note that it's not necessary to use this cable on...
Fusion Entertainment
Enhance your on-board audio entertainment experience with not only brilliant audio, but LED illumination options to match! The MS-RGBRC wireless remote lets you take control of your on-water...
ePower
ePOWER Remote to Suit 500/600/1k/2k ePOWER Inverter Remote control switch to suit 500/600/1k/2k ePOWER Inverters Part Number EPO-EN1REM
All brass body construction. Brass terminals and screws. Includes 2 keys. Can be mounted through a maximum 25mm dash. Part numberDescriptionVoltsN/ASAW-53304IGNITION SWITCH12V-
