Victron SCC010010050 Blue Solar Charge Controller PWM-LCD&USB 12/24V-10A
Liquid crystal display for status monitoring and set-up
Load output - Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage.
Some loads (especially inverters) can best be connected directly to the battery, and the inverter remote control connected to the load output. A special interface cable may be needed.
The connect and disconnect voltages are adjustable.
Day/night timing of the load output
This option allows for a pre-set ON-time after dusk.
Programmable battery charge algorithm
Pre-programmed algorithms for AGM, GEL, Flooded or LiFePO4 batteries (with internal BMS only)
Two 5 Volt USB outputs
Maximum current (both outputs combined): 2A
Specification:
- Battery Voltage: 12/24 V with automatic system voltage detection
- Rated charge current: 10A
- Automatic load disconnect: Yes
- Maximum solar voltage: 28V / 55V
- Self-consumption: < 10 mA
- Load output: Manual control + low voltage disconnect +timer
- Protection: Battery reverse polarity (fuse), Output short circuit, Over temperature
- Grounding: Common positive
- Operating temp. range: -35 to +60°C (full load)
- Humidity (non-condensing): Max 95%
| Part Number |
|---|
| VIC-SCC010010050 |
