Rule-Mate fully automatic submersible bilge pumps with Rule's exclusive "Spongeability" feature. All-in-one bilge pump & switch so no float switch required.
The innovative design incorporates the bilge pump and water sensor in a single housing.
Unique Rule "Spongeability" feature leaves the bilge the driest ever - when water in the bilge reaches a certain height the solid state sensor automatically activates and the pump runs until the water is pumped out, reducing boat weight, saving fuel and minimizing bilge odour.
Pump check feature - simply touch the pump check button on the pump and hold for a few seconds to test cycle the pump. These pumps have a threaded discharge port with O ring seal and are supplied with both 20mm 90-degree and straight hose ports.
Available in 12 volt or 24 volt.
3 year limited warranty.
- Fully automatic all-in-one submersible bilge pump systems
- No separate float switch required
- Bilge water sensor and pump in one common housing
- Pump and sensor are internally common wired for easy installation
- No battery drain other than when the pump is in use
- Removable strainer and impeller area are accessible to clear debris
- Threaded discharge ports for easy installation
- 1 each straight and 90 degree hose ports supplied with the pump
- A 3rd wire allows for manual over-ride using a Rule switch panel or it can activate an alarm or indicator lamp if desired
- Thermal overload protection
- Single touch pump check test button feature
All pumps are oval shaped - base footprint size : 110mm x 70mm.
Overall dimensions Inc straight hose port : 190mm L x 80mm W x 115mm H
| Part Number | Capacity | Power Supply | Current | Hose Outlets |
|---|---|---|---|---|
| RWB-824 | 800 GPH (50 LPM) | 12V | 3.0 Amps | 20mm (3/4") |
| RWB-825 | 800 GPH (50 LPM) | 24V | 1.5 Amps | 20mm (3/4") |
