Lone Star Marine Wiring Looms for GX Winches
Every anchoring system has to be wired in to operate. LSM Australia looms are made using tinned marine grade Australian Made oxygen free cable, H/D tinned copper lugs and epoxy filled heatshrink. These premade looms are a simple “plug and play” system saving hours on installation. The staff at Lone Star Marine are wiring loom specialists with many thousands of both generic and custom looms made for customers annually for every type of vessel.
Please see below for standard generic looms. Custom Looms can also be made for centre console and other non-standard boat configurations. Your retailer will require the “L” lengths
below before ordering.
Note:
- All LSM winches must be wired using the recommended cable size as noted in the installation manual. Please specify for GX or Elite winch.
- All LSM wiring looms are rated for winches to 2500W.
- Lone Star Marine only uses quality HD tinned lugs and dual wall epoxy filled heat shrink.
Loom Measurements
- L1. Battery to Switch Panel: Switch Panel mounting area of 100 x 100mm. This should be located to the left or above the steering position.
- L2. Battery to Solenoid: Solenoid can be mounted in a dry place anywhere between the Switch Panel and winch motor, but must be installed upright. Size is appr. 110x60x110. There will be four cables attached to the top.Under the dash or near winch motor is ideal.
- L3. Switch Panel to Solenoid
- L4. Solenoid to Winch Motor
Supplied installation instructions feature Placement Diagram & Switch Panel Template for easy installation.
| Part Number | Suits Runabout Style Boats |
|---|---|
| LSM-1000XS | 5.5m |
| LSM-1000S | 6.5m |
| LSM-1000L | 7.5m |
